24 September 2011

Building Tricopter with HobbyKing Quadcopter Board --- Unbox Pocket AVR Programmer

I am building a Tricopter and using HobbyKing Quadcopter Board by flashing the firmware with a Tricopter software.

This blog shows the unboxing the Pocket AVR Programmer which was purchased from Sparkfun.com. The programmer came with a 10-pin to 6-pin connector cable which will be used for connecting the board to the programmer.



The video below shows how to flash the HobbyKing Quadcopter Board.







2 comments :

  1. alekOctober 31, 2011 at 5:43 PM

    Hi, how do you flash HK board with it? I have it too but I do not know what SW should I use to upload new FW to the board. Thanks!

    ReplyDelete
  2. SubSonicNovember 1, 2011 at 9:17 PM

    I download this flash tool software and install it in your PC.

    Go to this website and follow the instruction.

    http://lazyzero.de/en/modellbau/kkmulticopterflashtool

    ReplyDelete

Subscribe to: Post Comments ( Atom )