23 September 2012

DIY Home made FPV console setup - EZ Hawk Sky

Materials:
Here is the final look of the setup and video:

EZ Hawk FPV Setup


Steps:

1: Use Polystyrene Sheet or thin plastic plate and cut to fit the fuselage. This will be your FPV console base. Tape the Velcro on both sides. See pictures below.



Cam Spec.
  • CCD sensor type:1/3 color SONY CCD   




  • Pixel;
  • NTSC: 510(H)*492(V) (included)  
  • PAL: 500(H)*582(V) 
  • Scanning system: Interlaced scanning
  • Synchronization: System:Inter
  • Horizontal resolution: 420TV line   
  • Minimum Illumination 0.01LUX/F1.2
  • DSP+CCD: CXD3142R+405AK 
  • S/N Ratio: 48dB   
  • Gamma Modification: 0.45   
  • White balance: Auto
  • Auto backlight compensation: Auto
  • Lens: 3.6MM
  • Audio: No
  • Input voltage: 9~12.6V 
  • Electric current 80MA 
  • Electronic Shutter: 1/50 (60) ~ 1/100,000s   
  • Video output: 1.0VP-P composite video   
  • Operation Temp.: -20~50
  • Size: 38*38mm 
  • Flight time: Approx 60min/100mah 3S

2: Glue a servo onto the sheet as shown below.



 

3: Mount cam onto the FPV Fiber Glass Pan and Tilt camera mount. See the pictures below.




4: Secure the cam and the FPV Fiber Glass Pan and Tilt camera mount on the servo.


5: Put the entire console on the plane. A few more pictures of the setup.

Note: Here is the link to my other page which talks about how to make the inverted vee antenna.





Camera spec.
CCD sensor type:1/3 color SONY CCD  
Pixel;
NTSC: 510(H)*492(V) (included) 
PAL: 500(H)*582(V)
Scanning system: Interlaced scanning
Synchronization: System:Inter
Horizontal resolution: 420TV line  
Minimum Illumination 0.01LUX/F1.2
DSP+CCD: CXD3142R+405AK
S/N Ratio: 48dB  
Gamma Modification: 0.45  
White balance: Auto
Auto backlight compensation: Auto
Lens: 3.6MM
Audio: No
Input voltage: 9~12.6V
Electric current 80MA
Electronic Shutter: 1/50 (60) ~ 1/100,000s  
Video output: 1.0VP-P composite video  
Operation Temp.: -20~50
Size: 38*38mm
Flight time: Approx 60min/100mah 3S





No comments :

Post a Comment