FPV New cl-osd display layout

First, I'd like to give credit to cl-osd for this display creation. The new modified OSD layout shown below is based on my own preferences

This is NTSC, imperial units, voltage 1, 2, and google coordinates always on configuration. This is a HobbyKing G-OSD II. I am using 900MHZ 200mW Tx/Rx & 1/3-inch CCD Camera NTSC.

Here are the eep and hex files that I share with you, and this is the entire File.

DIY Home made FPV console setup - EZ Hawk Sky

Materials:

• EZ Hawk Sky plane
• G-OSD II Mini with GPS
• 12 Channel 900Mhz Tx/Rx video system with CCD camera
  
• FPV Fiber Glass Pan and Tilt camera mount
• HXT 900 servos
• Home made Inverted Vee antenna (see here to find out how it was made!!!!!)
• Polystyrene Sheet or any thin plastic plate such as Corrugated Plastic sheet.
• Velcro Brand Sticky Back Tape (as needed)

Here is the final look of the setup and video:

Steps:

1: Use Polystyrene Sheet or thin plastic plate and cut to fit the fuselage. This will be your FPV console base. Tape the Velcro on both sides. See pictures below.

DIY Inverted Vee Antenna for FPV - 900MHz

This is my DIY inverted V antenna building experiences. Hope you find this useful. You may also find this from Aliexpress for a cheap price.

Here is the final product......

Materials needed----

• 12 AWG solid wire. It can be purchased from any local hardware store. It is a solid electrical wire. I bought 5 feet of it and it cost me US$1.50

• A few tie wraps as needed. See pictures below.

Tricopter - HobbyKing Quadcopter Frame

Had fun flying my Tricopter. Here is where I get it..

New Built TriCopter Maiden Flight

Just tuned the New Built Tricopter to feel comfortable to maiden it. Check out the video.

TriCopter from HobbyKing Quadcopter Frame V1

Here are a few photos of the modification in progress. I am trying to convert the quadcopter frame from HobbyKing to a Tricopter frame with minimum cut, drill and glue. In other words.....cheap but nice.

Building Tricopter with HobbyKing Quadcopter Board --- Installing AVR Programmer Driver

I am building a Tricopter and using HobbyKing Quadcopter Board by flashing the firmware with a Tricopter software.

This blog shows how to install Sparkfun Pocket AVR Programmer Driver for Window XP.

Building Tricopter with HobbyKing Quadcopter Board --- Unbox Pocket AVR Programmer

I am building a Tricopter and using HobbyKing Quadcopter Board by flashing the firmware with a Tricopter software.

This blog shows the unboxing the Pocket AVR Programmer which was purchased from Sparkfun.com. The programmer came with a 10-pin to 6-pin connector cable which will be used for connecting the board to the programmer.